Cable Blowing Lubricant, 5 gal.

When cable blowing, the cable stops moving when the frictional force resisting movement equals the blowing force producing movement. The maximum blowing distance varies linearly with friction coefficient in straight conduit sections. The friction reduction shown for Prelube 2000 can increase installation distance by a factor of 5 or more versus unlubricated duct. More information on these studies is published in our TeleTopics Newsletter Volume #11.

Application:
An airtight duct system with pressure-tight splices is critical to maximizing cable installation distance. Follow the equipment manufacturer’s instructions. Duct must be clean, dry and mandrel tested. Clean the duct by blowing a tight-fitting foam sponge through the duct with high pressure. If excess water or dirt exists, repeat this process. Prelube 2000 is effective at a coating thickness of 0.5 mg/cm².

For smoothwall duct and high air speed equipment with no missile, squeeze the recommended amount of Prelube 2000 Lubricant into the duct. Spread the lubricant by blowing a foam carrier through the duct. The squeeze bottle (cat# P-35) is a good package for this type of application.

For smoothwall duct 1 to 1.25 in/2.5-3.0 cm inner diameter and piston type machines, use 5 to 10 fl. oz. per thousand feet of duct/0.5 to 1.0 liter per kilometer. Place 75% of the lubricant in front and 25% behind the missle. The lubricant is spread by the missile as the cable is blown.

The quantities of lubricant appropriate for any job will vary with the size, type and condition of the duct. Use the recommendations above as a place to start and adjust as necessary.